14. ULLDENS

This program replace all well known conoscere ASTM tables for CRUDE OILS AND PRODUCTS.

Computer is more accurate than tables and interpolation between numbers is more quick. The program requires the observed temperature of the product in Celsius degrees; the Density at 15° and the observed volume in Cubic metres.

The output gives the following results:

1) Volume Correction Factor at 15°.
2) Weight Factor
3) Volume at 15° Celsius
4) Weight in long tons or in metric tons.
5) Print out of full report.

The program starts with a get ready calculation and you can see all calculation effected by striking always the RETURN KEY on your keyboard. You can change get ready inputs data with your new inputs and when you switch off your computer, all data inputs appear again when you switch it on. This procedure is very important to restrict time of all inputs data in the next calculation.

It is very important to remember that all ASTM tables (3, 54A, 54B, 53A, 53B, 6, 11, 23A, 23B, 54D,53D) cost about 800 U.S.$.

This program only 75$ and you can work very quickly when print your Ullage Report.